Wilson Combat Magazine Well, Blue

Great Addition to My Remington 1911R1..

Great addition, easy to install an fit great, just had to trim the back side of my grips to make it fit perfect.

Why did I wait?..

Fit my carry 1911 exactly as I hoped. Magazine change is quick and simple, I dont even have to look.

Excellent product!..

I puchased this for my Desert eagle 1911c and it fit almost prefectly. I just had to tap on it with a soft faced hammer to seat it properly on the frame. So far it hasnt gotten lose from light to heavy loads. In all it is a very good investment.

Great Mag well..

This is just what I needed. It was easy to install. I chose to modify the inside of the grip for a perfect flush fit, but the mag well works fine if you choose not to modify the inside of the grip.

Magwell for my Remington R1..

I bought this for my Remington R1 Enhanced. It fit really well and snug, with only some filing down with sandpaper of one of the hooks to get it to fit. Looks and fits great and does what its supposed to. Im happy. Someday Ill drop the cash on a WC pistol.

AWESOME!!!!!!!..

Just got the magwell in today and it fit great. Had no problems installing it. I highly recommend this product.

Sorry I waited so long to install it...

Fit great with just a bit of work to open the curve that fits around the grip screws. Sorry I waited so long to install it.

GREAT product and a must-have accessory..

I purchased this for my Colt Series-70 1911. It installed with fitting to the wood grips. I simply traced the outline of the magazine well mounting wings, then removed wood using my Dremel tool. Cleanup was done with a small file set and the grips were remounted without a problem. This took less than 30 minutes at my bench. A word about magazines, though... your flat bottom standard magazines will be hard to seat, as this well adds depth. I had to push these magazines in with my thumb rather than a tap on the heel of my hand. Since I have been converting my magazine collection to all Wilson-47Ds, which have an extended base, my motion will continue to be the same, a tap with the heel of my hand. And my original flat bottom magazines will go up on ebay.

Must have add on!..

Fits my Kimber Pro TLE 2 very well. Minimal fitting needed under grips, speeds reloading dramatically. Works flawlessly with 8rd KimPro Tac mags and 10rd Chip McCormick Power mags. Please note Kimber .22 conversion mags require fitting but nothing a dremel cant handle. Great Product!

just plain awesome..

I just got my magwell in and with just a little trimming it fit perferctly,gives my kimber a whole new look I absolutely love it, if it works like my other parts that I have purchased from wilson Im sure it will be great.

Didnt fit very well..

Tried to install this on my Para-USA GI Expert. Very tight fit and did not seat all the way, left a small gap between the bottom of the pistol and the top of the well. Other wise, a very strong, well made item,

UPDATE..

After shooting IDPA/CDP/NV at my local club for 4 matches. I went from the bottom half to placing 1st using this mag well. Thanks again W.C. Team, Great Product!

super snug!!!..

Awesome product for Springfield & Kimber.Cant wait to see how much time I shave reloading.Thanx W.C. Team!

Best Quick To Install Accessory!..

I have two of these that I use on Springfield Armory 1911s. They were quick and easy to install and greatly improve my reloads. This is an easy and affordable way to add a mag well.

Great Product!..

Easily Installed on Kimber 3 in.-The fit was perfect-The quality & craftsmanship was as good as claimed-which rarely happens anymore. Would recommend to anyone looking for a magazine well replacement or add on.